Welcome, Guest

Author Topic: Adjustment localizer courses based on AIRAC (Navigraph data)  (Read 1174 times)

Captain45

  • Forum Member
  • *
  • Posts: 2
Adjustment localizer courses based on AIRAC (Navigraph data)
« on: December 06, 2014, 11:25:30 am »
IN use: FSX, iFly737-800, UTE, UT2, AivlasoftEFB, ILSInspector and Editor (FSX)

Because of the mag var change the three ILSs of EIDW 28, 10 and 16 now have a loc crs of 280, 100, 162
The Navigraph data for these ILSs read today: 279, 099 and 161.
My CDU always gives me an error on approach because of this.
I tried to correct this using the ILSInspector software, which works fine on every other occasion.
I used the file D:\FSX\Eiresim Dublin 2009\EIDW\Scenery\EIDW_ADEX_ADE.BGL presuming that this is the correct BGL (could not find another one).
Funny enough by reading that file, ILSInspector finds 6 ILSs instead of 3.
And when I pick on of the three, change it based on the AIRAC data (just 1 mouseclick), I can not save the new values because of the error message "An ILS with the same identifier already exists on another runway."  That happens on all three.  This makes it impossible for me to make all values in line with the AIRAC data.

Probably there is a reason for this to happen. Is there a solution for my wish to get things right?